| MATERIAL |
PADDLE MIXING |
MACHINE MIXING |
| PLASTERS |
|
|
Hardwall, browning, backing & undercoat plasters |
Backing plasters are quite heavy to mix and are often mixed two or three bags at a time
The MM21 or MM22 MEGAMIXERS with an MR3 5in paddle are recommended for a daily output of 150 square metres a day. For more constant use the MM29 or MM30 with an MR3 6in paddle is suggested |
For mixing of hardwall use the RMX100 ROTAMIXER
This mixer will turnout a bag in about 2 minutes upto 20 bags an hour
Hardwall can also be mixed and pumped through the M22 Mixer Pump. This machine will take dry powder, mix and pump it to the spray gun for application |
Multi-finish & setting plasters |
These are lighter plasters that are applied as a thinner topcoat over backing plasters or plasterboard
The MM19, MM21 or MM22 MEGAMIXERS with 5in MR3 paddle are recommended |
|
One coat & projection plasters |
One coat plaster can be mixed using the MM21 or MM22 MEGAMIXERS with an MR3 5in paddle for a daily output of 150 square metres a day. For more constant use the MM29 or MM30 with an MR3 6in paddle is suggested |
These plasters are suitable for machine application with the M22 and M5 Mixer Pumps
These machines will take dry powder, mix and pump it to the spray gun for application |
| DRYWALL COMPOUNDS |
|
|
| Bonding compound |
Bonding compound is sticky and heavy to mix
The MM21 or MM22 MEGAMIXERS with an MR3 5in paddle are recommended for a single bag mixes
For more constant use the MM29 or MM30 with an MR3 6in paddle is suggested |
|
| Board finish plasters |
These are lighter plasters that are applied as a thinner topcoat over plasterboard
The MM19, MM21 or MM22 MEGAMIXERS with 5in MR3 paddle are recommended |
|
Artex & textured coatings |
Artex is normally mixed a bag at a time
The MM19, MM21 or MM22 MEGAMIXERS with 5in MR3 paddle are recommended |
|
| Links |
Gypsum Products & Producers |
|
RENDERS |
|
|
Sand & cement renders |
For patching or where specialist admixes or polymers are being used, the MM29 or MM30 with an MR3 6in paddle are recommended |
Cement mixers are traditionally used for knocking up sand and cement renders
Increasingly higher quality mixes are required; for these renders use the RMX100 or RMX200 ROTAMIXER |
One coat renders & colour through renders |
Polymer and silicone renders are normally used in large volumes and need a constant supply of mixed material
The MM29 or MM30 MEGAMIXERS with an MR3 6in paddle are recommended |
For trowel application these renders can be mixed using the RMX100 or RMX200 ROTAMIXERS
Many of these bagged renders can be spray applied using a mixer pump |
